Logo

C0091 BMW Fault Code

Check C0091 OBD Fault Code Reason
Description:

Throttle Position (TP) Sensor Intermittent The TP sensor circuit is monitored by the PCM for sudden BMW TP rotation angle (or voltage) input change through the comprehensive component monitor (CCM). If during the last 80 warm-up cycles in key ON engine running the BMW PCM detects a TP rotation angle (or voltage) changes beyond the minimum or maximum calibrated limit, a continuous diagnostic trouble code (DTC) is stored. Poor continuity through the TP sensor connectors Poor continuity through the TP harness Intermittent open or short inside the TP sensor While accessing the TP V PID on the scan tool, lightly tap on the TP sensor or wiggle the TP sensor connector and harness.

C0091 Code Symptoms :

See C0091 in engine

The original multi-displacement system turned off opposite pairs of cylinders, allowing the engine to have three different configurations and displacements. C0091 code had an elaborate diagnostics procedure, including showing engine trouble codes on the air conditionning display. However, the system was troublesome, misunderstood by customers, and a rash of unpredictable failures led to the technology being quickly retired.

Diagnosis And Repairing C0091

C0091 OBD2 specifically refers to the camshaft (cam) timing. In this case, if the cam timing is over-retarded, the engine light will be illluminated and the code will be set.

How to fix C0091 code ?

See C0091 repair manual
  • Air fuel ratio (A/F) Sensor 1 Bank 1 circuit poor electrical connection
  • Faulty Crankshaft Position Sensor (POS)
  • Dirty Oil
  • Faulty Fuel injector

BMW Cars that meet C0091 error